Existing electricity supplies

If it has been noted that the property's existing cutout fuse is faulty, but isn’t dangerous, we will replace the cutout fuse with one of identical capacity. 

Change cut out

We can temporarily de-energise your supply to allow you to complete other work. (This can only be for a maximum interruption of 72 consecutive hours. If you require your power to be off longer or permanently, you will require a disconnection.)

De-energise/re-energise

When your property no longer needs an electricity supply, for example, because it is going to be demolished, please contact us, so we can disconnect it from the mains network and make it safe.

Disconnections

Have you just purchased or considering buying an electric vehicle? Visit our EV page for more information on how to apply to connect an EV charger.

Electric vehicle

We recommend speaking to an electrician or installer to see if your home wiring is sufficient to support a heat pump, or if you need to upgrade your supply or apply for a new connection.

The UK and Scottish Governments have set ambitious targets to rapidly increase heat pump and zero-emission heating system installations in the coming decade. SSEN is committed to ensuring this transition is managed fairly for the households, businesses, and communities it serves.

Read more about how to apply to connect your heat pump.

Heat pumps

You may need to upgrade your supply if you’re making changes to your property, like adding a large piece of electrical equipment.

You may want to decrease your supply if you have removed a large piece of equipment from your property.

Change in capacity

If you’re installing a new appliance or connecting something which may take more demand from your electricity supply, you will need a load check to see if your supply can handle this.

Load check

Where the box is damaged beyond repair you will need to supply a replacement box which we will usually fit free of charge.

Replace meter box

If the meter board is damaged or missing and our equipment is attached to it (cut out fuse or power cable), we will investigate this.

Replace meter board

A service alteration is a change to the location of your supply point and meter. You may need to apply for a service alteration if you are renovating your property, building an extension, or demolishing a part of the property that may require you to move your meter.

Service alteration

If it has been noted that the property's existing cut out fuse is faulty, but isn’t dangerous, we will replace the cut out fuse with one of identical capacity. 

Change cut out

When your property no longer needs an electricity supply, for example, we can disconnect it from the mains network and make it safe.

Disconnection

If you need any of our existing overhead lines, underground cables, or electrical equipment diverted as part of your project, you will need to apply for a diversion

Diversion

Just bought an EV? Or thinking of getting an EV? Or are you looking to connect multiple EV charging points? Visit our electric vehicle page for more information.

We recommend first speaking to an electrician or installer to see if your home wiring is sufficient to support an electric vehicle charger, or if you need to upgrade your supply or apply for a new connection.

EV Chargers

We will attempt to repair damaged meter boxes free of charge. Where the box is damaged beyond repair you will need to supply a replacement box.

Replace meter box

We recommend speaking to an electrician or installer to see if your home wiring is sufficient to support a heat pump, or if you need to upgrade your supply or apply for a new connection.

The UK and Scottish Governments have set ambitious targets to rapidly increase heat pump and zero-emission heating system installations in the coming decade. SSEN is committed to ensuring this transition is managed fairly for the households, businesses, and communities it serves.

Read more about how to apply to connect your heat pump.

Heat pumps

You may need to upgrade your supply if you’re making changes to your property, like adding a large piece of electrical equipment.

You may want to decrease your supply if you have removed a large piece of equipment from your property.

Change in capacity

You may need to upgrade your supply if you’re making changes to your property, like adding solar panels to your property.

You may want to decrease your supply if you have removed a large piece of equipment from your property.

Change in capacity

If you’re installing a new appliance or connecting something which may take more demand from your electricity supply, you will need a load check to see if your supply can handle this.

Load check

Apply here if you need to move your supply location far enough that it will change the location of your meter.

Service alteration

If the meter board is damaged or missing and our equipment is attached to it (cut out fuse or power cable), we will investigate this. 

Meter board replacement

We will attempt to repair damaged meter box doors free of charge. Where the box is damaged beyond repair, you will need to supply a replacement box 

Meter box door replacement

If you're planning to carry out building work or drive tall vehicles under our overhead cables, we will attend site and ensure that they are at a correct and safe height for the works underneath or around. 

Overhead assessment

We will arrange for an engineer to attend to check if PME, is available at your property. We will also update our equipment to accommodate the connection and connect this for you.

PME Check

If you've noticed a pole leaning or a damaged stay, then we can attend and assess how secure the pole is.

Pole assessment

If your power cable is attached to a bracket that has a screw missing or is coming away from the property, we will attend the site and re-fix the bracket (unless deemed an emergency).

Refix bracket

We can repair or replace the cable or wire that supplies you with electricity.

Renew lead in

We can cover our overhead cables with a sleeve to ensure you are safe when working nearby.

Shrouding

We can temporarily isolate your incoming electricity supply.

Temporary isolation

We can arrange for a tree cutter or Arborist to attend the site in order to inspect the tree(s) to determine what work is required.

Tree cutting

We can attend your property and remove the electricity cable from the wall to enable you to complete your maintenance work (such as painting the property or replacing the fascias). Once your work is complete, we can then re-attach your cable back in its original location. 

Unclip/reclip

We can carry underground cable assessment to make sure no cables are within the area around your property where you plan to work.

Cable trace

If you have a Framework Agreement in place you can request joint use of any SSEN LV poles. 

Apply now

You may need to upgrade your supply if you’re making changes to your property, like adding solar panels to your property.

You may want to decrease your supply if you have removed a large piece of equipment from your property.

Change in capacity

If you're planning to carry out building work or drive tall vehicles under our overhead cables, we will attend site and ensure that they are at a correct and safe height for the works underneath or around. 

Overhead assessment

If you've noticed a pole leaning or a damaged stay, then we can attend and assess how secure the pole is.

Pole assessment

We can cover our overhead cables with a sleeve to ensure you are safe when working nearby.

Shrouding

We can provide access to one of our substations.

Substation access

If one of our substations contain rubbish has been subject to fly tipping, or has become overgrown with vegetation, we can attend to have it removed.

Substation clearance

If we receive a report that a substation we are responsible for needs to be repaired (broken gate, fence, locks, etc), we will arrange for one of our specialists to attend and carry out the repairs required.

Substation repair

We can temporarily isolate your incoming electricity supply.

Temporary isolation

We can arrange for a tree cutter or Arborist to attend the site in order to inspect the tree(s) to determine what work is required.

Tree cutting

If you need any of our existing overhead lines, underground cables, or electrical equipment diverted as part of your project, you will need to apply for a diversion.

Diversions

If you're planning to carry out building work or drive tall vehicles under our overhead cables, we will attend site and ensure that they are at a correct and safe height for the works underneath or around. 

Overhead assessment

If you've noticed a pole leaning or a damaged stay, then we can attend and assess how secure the pole is.

Pole assessment

If your power cable is attached to a bracket that has a screw missing or is coming away from the property, we will attend the site and re-fix the bracket (unless deemed an emergency).

Refix bracket

We can cover our overhead cables with a sleeve to ensure you are safe when working nearby.

Shrouding

A service alteration is a change to the location of your supply point and meter. You may need to apply for a service alteration if you are renovating your property, building an extension, or demolishing a part of the property that may require you to move your meter.

Service alteration

We can arrange for a tree cutter or Arborist to attend the site in order to inspect the tree(s) to determine what work is required.

Tree cutting

We can attend your property and remove the electricity cable from the wall to enable you to complete your maintenance work (such as painting the property or replacing the fascias). Once your work is complete, we can then re-attach your cable back in its original location. 

Unclip/reclip

If you need any of our existing overhead lines, underground cables, or electrical equipment diverted as part of your project, you will need to apply for a diversion.

Diversions

We will arrange for an engineer to attend to check if PME, is available at your property. We will also update our equipment to accommodate the connection and connect this for you.

PME Check

A service alteration is a change to the location of your supply point and meter. You may need to apply for a service alteration if you are renovating your property, building an extension, or demolishing a part of the property that may require you to move your meter.

Service alteration

We can carry underground cable assessment to make sure no cables are within the area around your property where you plan to work.

Cable trace